User`s manual

Chapter 2 - Unpacking and Setup of Your Printer
9
Placement of the Shirt Board
When placing your Shirt Board within the Pint Bed, take care to align the item carefully. Failure to seat
the Shirt Board completely in the four Guide Pins can result in an unsteady print surface and errors in
your output.
For reference, the Blazer Express standard-sized
Shirt Board should be placed in the Landscape orientation when
facing the front of the machine..
The oversized Shirt Board is to be mounted in the
Portrait orientation.
Both Shirt Boards have
Yellow and Black “This Side Out”
stickers to assist you with placement. Before operating the
printer, ensure these labels can be viewed from the Load
position.
Blazer PRO SETUP
FOR INFORMATION ON THE BLAZER EXPRESS, SEE THE
BLAZER EXPRESS SECTION EARLIER IN THIS CHAPTER.
Unpacking the T-Jet Blazer PRO
The Blazer Pro is shipped fully assembled in one large crate.
The only additional item you will need to install is the User
Interface (UI).
You should have received and signed a Pre-Installation
Checklist prior to the arrival of your printer. This Checklist
outlined the importance of room conditions, uncrating and
assembly and all the other details necessary for your machine
to maintain optimal performance levels.
Moving the Blazer PRO
IMPORTANT NOTE:
The printer and base weigh over 400 pounds. Because of
the bulk of the machine, this is a FOUR PERSON lift.
DO NOT attempt to lift the machine from the crate with
less than four people. Position one person at each of the
four corners of the machine and make sure that lifting is
done from the base as identied on the right.
Landscape
Portrait
Lift all four
corners evenly
from this point