User`s manual
Appendix A - Operational Guide
175
4. Receive the equipment properly. Use appropriate personnel and equipment to off-load and move the
shipping containers to a storage area or directly to a staging area. The Fast T-Jet Blazer Express ships in a
single crate that is large and must be handled with the use of a forklift, lift gate or pallet jack. The crated
printer and components weigh over 300 pounds (227 kg).
Before moving shipping containers from the receiving area, check corridors and doorways for clearance
and remove any obstacles. The Express model must have a doorway clearance of a minimum of 36 inches
(92 cm).
5. Make sure the preparations for the system set up are complete. It is essential to have all utilities (HVAC
and electrical) available at the time of installation. Use trained personnel to assist with the installation in
each of these areas. The Fast T-Jet Blazer Express printer must be on a dedicated power line that has at
least 15 amps. It can be hooked up to 110v or 240v service. It is dual voltage.
6. Agree to perform simple Daily and Weekly Maintenance procedures outlined in the User’s Manual,
including keeping the Print Head and Capping Station cleaned.
Room Preparation
The rst step in preparing the workspace is to plan the location of each system component. Make a
complete list of all equipment and supplies to be accommodated in your garment printing area and dene
the workow between this equipment. Identify efcient operational techniques.
Environment
The printer will operate best in a clean, dust-free room at a steady temperature between 68° F and 85° F
(20° C and 29° C) with a relative humidity between 40% and 60% (non -condensing).
Operation of the printer at a relative humidity below 40% or above or below the recommended
temperature range will result in poor nozzle print performance and poor print image quality. This may
result in the User voiding the warranty.
The workspace oor should be easily cleaned and should not generate dust or static electricity. It should
be noted that decorating the room in neutral gray colors and using pure white (“daylight”) lights would
aid operators and clients in judging color accuracy.
Ideally, the Fast T-Jet Blazer Express printer should not be installed in the same room as other equipment
that can potentially cause an ink mist or excessive dust. This includes, but is not limited to, the
Pretreatment used when printing with White ink. If this is unavoidable, the printer should be isolated,
either by efcient extraction of mist and fumes or by partitioning. Heavy dust and ink mist can cause
reliability problems with the printer.
It MUST not be placed in an open warehouse that is hot, dry, dusty or has excessive oor vibration. If you
must place it in an open room that is not environmentally controlled, you can build a temporary enclosure
out of plastic and building materials. This enclosure must comply with local building codes.