User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
172
Step 9: Attach the padded bracers to the top of the PRO.
Attach the 2 padded bracers to the top of the PRO.
A padded bracer will sit on the front and back side
of the printer assembly and will fasten from the
outside of each side plate wall.
One screw on each side for each bracer will hold
them in place.
Step 10: Fasten the crate lid.
Fasten the crate lid to the top of the nearly
completed crate.
Use a total of 10 screws as shown, and fasten to
the top of each crate wall plate.
IF YOU HAVE ANY PROBLEMS IN CRATING YOUR BLAZER PRO, CALL OUR SUPPORT LINE
AT 1-888-MYT-JETS AND WE WILL GLADLY WALK YOU THROUGH ANDY TROUBLES OR
CONCERNS. HAVE YOUR SERIAL # AND HISTORY READY.