User`s manual

Chapter 16 - Product Support
169
After the rst set of bracers are fastened, a
second set of bracers (30” in length) will go right over
the top of them. These will hold the printer from moving
front to back.
NOTE: If you have
the protective plastic
cover, place it over the Blazer PRO.
Step 3: Attach Vertical Bracers.
Next, fasten the vertical bracers (4 total) to the crate
frame guides, towards the middle of each side of the
crate as shown.
Each vertical
bracer is 46 1/2”
in height and
requires 2 wood
screws each.
Step 4: Attach Upper Bracers.
The upper bracers (42 1/2” in length) will hold the
vertical bracers together and will help make them
sturdy. They will also be fastened to the wall plates in
a later step.
Attach the 2 bracers with to outside edge of the the
vertical bracers.
One screw
should be
enough per
side, per
bracer.