User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
168
Re-crating the Blazer PRO
Follow these instructions to re-crate your Blazer PRO for any time the machine will need to travel or be
shipped. If you have any questions or problems re-crating, call our support department for assistance.
Preparations:
For this procedure you will need all of the original crate supplies and bracers, 3 assistants to help lift,
long 2 1/2” wood screws and a power drill equipped with a phillips-head drill bit. This procedure may
take up to 1 hour to complete correctly. Make sure that you follow all instructions on transporting your
printer including installing cleaning cartridges and locking the Print Head in place. The Printer Assembly
needs to be positioned directly in the middle of the unit. NOTE: The red indications on the illustrations
symbolize where a screw is needed.
Step 1: Place the Blazer PRO on the
Crate Bottom
The printer needs to sit on the crate bottom in between the supports. The
crate bottom has blue foam material on it to protect the frame
of the Blazer PRO.
Make sure the printer
sits correctly or the
printer may move
around while
shipping or
transporting.
Step 2: Attach Bottom Bracers.
There are 2 sets of bracers that attach to the crate bottom
and hold the Blazer PRO down to prevent movement.
The rst set (56” in length) will lay down length-wise
along each side of the machine and will need to be
fastened using wood screws into the crate frame guides.
NOTE: Try to use
the original screw
holes if possible.
Too many holes
in the wood will
weaken or even
break the wood.