User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
166
Re-crating the Blazer EXPRESS
Follow these instructions to re-crate your Blazer EXPRESS for any time the machine will need to travel
or be shipped. If you have any questions or problems, call our support department for assistance.
Preparations:
For this procedure you will need all of the original crate supplies, a power drill equipped with a phillips-
head drill bit, 2 1/2” wood screws and an assistants to help lift from crate. Make sure that you follow all
instructions on transporting your printer including installing cleaning cartridges and locking the Print
Head in place. NOTE: The red indications on the illustrations symbolize where a screw is needed.
Step 1: Place the Blazer EXPRESS on the Crate Bottom
The Blazer Express needs to sit on the crate
bottom as shown.
Make sure it sits correctly or the printer may
move around while shipping or transporting.
Also, make sure that you follow all
instructions on transporting your printer
including installing cleaning cartridges and
locking the Print Head in place.
Step 2: Lower the walls of the crate.
If removed properly, you should be able to
drop the walls with the braces in tact as
shown.
NOTE: The braces only t one way.