User`s manual
T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
160
Press the far right button or MENU button to get into the menu.•
The very rst option on the screen should be PRINTER SETUP. Press MENU again to enter into •
the PRINTER SETUP conguration.
The screen will read PLATEN GAP. Use the up and down arrows to browse all of the settings that
•
can be changed. Press MENU to enter a topic and use the up and down arrows to nd the setting
you want. Once you have selected a setting, press MENU again to select that option. Browse
through the entire list and verify that all of the settings are set to the list below.
PLATEN GAP -- *STD
PAGE LINE -- *OFF
INTERFACE -- *AUTO
CODE PAGE -- *PC437
PPR MARGIN -- *DEFAULT
PPR SIZE CHK -- *OFF
CUTTER ADJ -- DO NOT USE OR CHANGE
REFRESH MRGN -- *OFF
AUTO NZL CHECK -- *OFF
AUTO CLEANING -- *OFF
QUIET CUT -- *OFF
INIT SETTING – DO NOT USE – WILL RESET EVERYTHING
After completing the settings routine in the previous step, turn off the printer and remove the paper 6.
from the shirt board.
The last step in the process is to turn the printer back on, allow it to complete the startup cycle and
7.
continue printing shirts.
If you have questions, or your problem persists after completing these instructions, please call
Technical Support at 888-698-5387 or send an e-mail to support@usscreen.com. Remember to
include your serial number and repair records when emailing or have them ready when calling.