User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
158
If you have questions, or your problem persists after completing these instructions, please call
Technical Support at 888-698-5387 or send an e-mail to [e-mail]. Remember to
include your serial number and repair record(s) when emailing or have them ready when calling.
Error Code: 1001E Blazer Express
Cause 1:
The Height Sensor has been tripped too many times.
Solution: Lower the Shirt Board (Increase the Platen to Head Clearance).
Prevention: Pay attention to the MINIMUM clearance of 3mm between the Print Head and Shirt Board
(Platen).
Cause 2:
The Page Size is too big.
Solution: Decrease the Page Size to a maximum of 17” x 30”
Prevention: Practice working in FastARTIST using the supplied Art Layout Templates. See Chapter
10 - Printing Basics as well as the Art Layout Chapter in your FastARTIST User’s Manual.
Error Code: 1001E Blazer PRO
The Page Size is too big.
Solution: Decrease the Page Size to a maximum of 17” x 45”
Prevention: Practice working in FastARTIST using the supplied Art Layout Templates. See Chapter
10 - Printing Basics as well as the Art Layout Chapter in your FastARTIST User’s Manual.
Error Code: 10031
The printer is not in the correct print mode
Solution: If performing maintenance such as a Nozzle Check, make sure you follow the directions in this
manual when changing and switching print modes. Refer to Chapter 8 - Initialization Utilities.