User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
156
Binding Solution for the PRO:
Adjusting the Lead Screw Bracket
The Lead Screw Bracket (or front Drive Screw Mount) should be
vertical, not at an angle.
If the Lead Screw Bracket is only slightly angled, gently tap it to
1.
straighten. Doing this can eliminate binding issues. If this did not
help the level of the Lead Screw Bracket, continue on with step 2.
In the event that the block is severely angled, remove the 3 hex
2.
screws that secure it in place.
Pull the Drive Screw downward to facilitate removing the block. Put
3.
the block back on the drive, checking for true verticality.
Reattach the block using the 3 hex screws, but only tighten to “nger
4.
tight.”
Move the Print Assembly forward until it sits about 5” from the Limit Switch. This will ensure the
5.
Drive Screw is level and in the correct position.
Tighten the 3 screws and send the printer back to
6. Home position. Set the passes to 2 or more and
press the 2 Green buttons on the User Interface.
Make sure the printer goes forward and back without binding.
7.
If you have questions, or your problem persists after completing these instructions, please call
Technical Support at 888-698-5387 or send an e-mail to [e-mail]. Remember to
include your serial number and repair record(s) when emailing or have them ready when calling.
Error Code: 10004
The Encoder Strip is not being read properly.
Solution 1: Clean the Encoder Strip. Refer to Chapter 13 - Daily, Weekly and Montly Maintenance.
Prevention 1: Follow Daily Maintenance Routines
Solution 2: Make sure the Encoder Strip is seated properly in the sensor. The sensor is located in the
center of the Encoder Strip. If it’s crooked or is not securely in place, GENTLY position it back into place.
Prevention 2: Be extra careful of the Encoder Strip when performing any maintenance routines.
Lead Screw
Bracket
Drive
Screw