User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
152
Error Code: 10000
The fuse is blown (Express model) causing the print bed to sit on the index sensor.
Solution: You will need to replace the 5 amp fuse on the DC Motor Control Board. Follow the
instructions below.
Error Code 10000 Solution for the Blazer Express:
Replacing the DC Motor Control Board Fuse
What you will need
4 mm Allen Wrench•
Phillips Screwdriver•
5 amp fuse (supplied with printer)•
1. Remove the 6 screws on the left side access panel.
Caution: The side panel is not secured without the screws in place. The panel will fall if not
supported.
2. Locate the 5 amp fuse on the DC Motor Control Board.