User`s manual
T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
126
• Next, gently slide the metal cowling free and
the Waste Tank will be easily accessible. To remove
the Waste Tank, slide if from its bin.
Always r eplace the Waste Ink Tank or Pad
•
Reset the Chip
•
Next, use the Chip Reset Module to reset the Waste Tank chip. For instructions on resetting
the chip, refer to Chapter 3 - The Bulk Ink System - Resetting the Bulk Ink Cartridges. The
instructions for resetting a bulk ink cartridge also apply to the Waste Ink Tank.
Replace the Waste Tank
•
Slide the Waste Tank back into place and reattach the metal face plate.
WARNING: DO NOT reset the Waste Ink Tank chip without rst replacing the
pad. Practicing this correct method will leave your Waste Ink Tank monitor on the
LCD accurate. Failure to change the Waste Ink Tank pads when necessary WILL
cause ink to overow from the Tank and onto critical components of your printer.
In addition to having a large mess to clean up, you may short out the motherboard.
This will be very costly in terms of downtime and repair expense. Damage from
this type of incident is NOT covered by any warranty.
IMPORTANT POINT
U.S. Screen is not liable for any damage caused by ink to property such as carpets,
ooring or furniture . Please read and understand all operating and maintenance
procedures before using the Fast T-Jet Blazer Express.
3. Agitate Your Stored White Ink
As explained in Chapter 11 - Advanced Printing With White Ink, the white ink requires
a weekly agitation to keep the pigment suspended. For best results, shake the bottle
vigorously for at least 1 minute.