User`s manual

Chapter 12 - Printing Other Items
119
and pilot lights and turn off stoves, heaters, electric motors and other sources of ignition during use and
until all vapors are gone. Prevent buildup of vapors by opening all windows and doors to achieve cross
ventilation. Use only with adequate ventilation. Do not breathe dust, vapors or spray mist. Ensure fresh
air entry during application and drying. If you experience eye watering, headache or dizziness or if air
monitoring demonstrates that vapor/mist levels are above applicable limits, wear an appropriate, properly
lled respirator (NIOSH/MSHA approved) during and after application. Follow respirator manufacturer’s
directions for respirator use. Avoid contact with eyes, skin and clothing. Wash thoroughly after handling.
KEEP OUT OF REACH OF CHILDREN
First Aid: in case of contact, immediately ush eyes or skin with plenty of water for at least 15 minutes.
Remove contaminated clothing and shoes. Get medical attention. Wash clothing before reuse. If
swallowed, get medical attention immediately. If you experience difculty in breathing, leave the area
to obtain fresh air. If continued difculty is experienced, get medical assistance immediately. If spilled,
contain spilled material and remove with inert absorbent. Dispose of contaminated absorbent, container
and unused contents in accordance with local, state and federal regulations.
The Manufacturer shall not be liable for loss or damages whether direct, indirect, incidental or
consequential, regardless of the legal theory asserted, including negligence and strict liability. Read
Material Safety Data Sheet before use.
Non-Textile Printing Tips
When brushing on any of the treatments, make sure they are applied in smooth, even and thin •
layers.
Having two brushes can make the pretreatment and priming processes easier. Use one for the
•
Non-Textile Primer and one for the Non-Textile Pretreatment.
Cleaning the brushes when done with hot water and letting dry will prevent them from drying out
•
and ruining the brushes.
When printing on Non-Textile items, use a piece of lm that covers the whole item and print a test
•
print on the lm to see if it is in alignment with the desired printing area.
The maximum printable area of a Fast T-Jet Blazer Express is 17” x 47”. To maximize production,
•
you can line up multiple items to print more then one item at a time.
If you have a Heat Press, you may dry items faster by placing them under the element, but you
•
MUST avoid contact between the item and the heated surface.