User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
118
Choose a Print Mode (Non-textile Print Mode). For a list and description of the available Print 3.
Modes, please refer to your FastARTIST User’s Manual.
Print to FastRIP.
4.
T-Jet Non-Textile Post-Treatment
This Post-Treatment is a protective coating used for prints on non-textile surfaces. Using the post-
treatment will prevent fading of ink colors, extend the life of the image as well as waterproong and
acting as a UV protectant.
APPLICATION DIRECTIONS:
Shake the can before each use. After all ink has dried thoroughly,
apply a thin coat, holding the can 4 to 8 inches from surface and
using a swift motion to prevent overspray and unwanted build-up. If
build-up does occur, use a lacquer thinner to remove. A second coat
may be applied after approximately two minutes of drying time.
Allow treated surfaces to dry for 30 minutes to one hour in a clean,
dust free area before handling. Allow 24 hours cure time prior to
placing coated articles into service.
Clean the valve after use by turning the can upside down and spraying a short burst until cleared. If the
nozzle is clogged or sprays irregularly, check for clogging within the opening. Scrape off excess coating
with a soft object and twist the valve one half turn to close.
Post Treatment Warnings and Safety
Information
Use Fast T-Jet Non-Textile Post-Treatment only in a well ventilated area.
Fast T-Jet Non-Textile Post-Treatment VAPOR is HARMFUL and MAY AFFECT THE BRAIN OR
central NERVOUS SYSTEM, CAUSING DIZZINESS, HEADACHE OR NAUSEA. It may CAUSE
NOSE, THROAT IRRITATION and LUNG IRRITATION. OVEREXPOSURE MAY CAUSE LIVER,
KIDNEY OR BLOOD DAMAGE. It may CAUSE EYE or SKIN IRRITATION. Fast T-Jet Non-Textile
Post-Treatment is HARMFUL IF SWALLOWED.
Reports have associated repeated and prolonged occupational exposure to solvents with permanent brain
and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents
may be harmful or fatal.
CAUTION: Do not puncture or incinerate (burn) container. Exposure to heat or prolonged exposure to
sun may cause bursting. Do not expose to heat or store at temperatures above 120°F. Vapors may ignite
explosively. Keep away from heat, sparks and ame.
VAPORS MAY CAUSE FLASH FIRE. Do not smoke while using this product. Extinguish all ames