User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
114
T-Jet Non-Textile Primer
Fast T-Jet Non-Textile Primer is designed to be used on high gloss, non-porous surfaces
as a primer coat prior to the application of our standard T-Jet Brand Non-Textile
Pretreatment.
DO NOT print directly onto this product.
Protect your work surfaces with newspaper.
APPLICATION DIRECTIONS:
Dip a ne bristle brush into the Primer, wiping off any excess on
•
the side of the bottle. Gently brush Primer over the surface of the
non-textile item, making sure there are no uneven areas.
The Primer must be applied in a thin even layer to ensure optimal
print quality.
After the application is complete, clean the brush thoroughly with
•
hot water to remove all Primer residue.
IMPORTANT POINT
This product can be sprayed on, but the application may not be as smooth as
necessary for good print reproduction. If applying with an airbrush, spray bottle
or paint sprayer, you may need to dilute the solution with water. If you dilute the
Primer, two coats may be necessary.
Clean up spills and brushes with soap and water immediately after use.
•
Allow the Primer to dry thoroughly before applying the Non-Textile Pretreatment. Dry time will •
vary but can take up to one hour or more. To speed up the drying process, you may use a hair dryer,
heat lamp or a heat gun set on a low temperature setting.
A Heat Press may also be used by setting the non-textile item under the heating element. However,
•
DO NOT allow the heating element to touch the non-textile item.