User`s manual

Chapter 12 - Printing Other Items
113
Non-Textile Printing
Required Items and Overview
You must have the following to successfully
print on Non-Textile items:
Non-Textile Pretreatment1.
Non-Textile Post-Treatment2.
ne bristle brush3.
Optional materials may be required:
Non-Textile Primer
1.
a holder for object(s) (i.e. Golf Ball Holder)2.
an extra brush or two3.
Non-Textile Print Modes and Templates: utilize the latest Non-Textile Print Modes by downloading 4.
the most recent Printer Package from www.myt-jet.com
CAUTION: WEAR GLOVES WHEN APPLYING AND USE WITH ADEQUATE
VENTILATION. HANDLE WITH CARE AND PROTECT EYES WITH SAFETY
GLASSES WHEN APPLYING AS A SPRAY. BEFORE USE, CONSULT THE
MATERIAL DATA SAFETY SHEET (MSDS) THAT IS INCLUDED WITH
THESE PRODUCTS
KEEP OUT OF REACH OF CHILDREN
Getting Started
It is necessary to determine if the surface intended for printing will allow the Pretreatment to stick.
Certain surfaces will accept the direct application of the Non-Textile Pretreatment, while others will
require rst require a coat of Non-Textile Primer. Generally, smooth surfaces such as light switches,
keyboards, lighters and gloss tiles will require an application of Non-Textile Primer before the Non-
Textile Pretreatment.
To Test: Apply a very small thin amount of Non-Textile Pretreatment to the intended printing surface. If
the Pretreatment runs off, it will be necessary to use the Non-Textile Primer.
If this is your rst time using a Non-Textile Pretreatment, it is recommended you
pretreat small quantities at rst to familiarize yourself with the process.