User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
112
FastARTIST Page Size – Go to Layout > Page Size
FastRIP Setup – Go to File > FastRIP Setup
For more information about printing on caps or Non-Textile, such as golf balls, there is a downloadable
PDF available at www.screenprinters.net.
Adjusting the Platen Height
Before sending any print, check the Platen/Print Bed to Head Clearance. You will most likely need to
adjust it when printing other items. For the best prints, the printable surface should set to 1/8inch (3mm)
below the Print Head. If the item has a seam or excess fabric, these areas should be lower than the main
printing surface. Refer to Chapter 8 - Initialization Utilities for the proper steps.
WARNING:
Make sure that the printable item has the required distance of at least 3mm from
the print head. Also be extra careful with other items while releasing and sliding
the carriage over. If the bed is much too high, you can accidentlay damage it if
being careless.