User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
96
The T-Jet Blazer Express is equipped with an Emergency Kill Switch that will cut OFF all power to the
printer. After pressing this button, you must shutdown the machine completely, including the Power
Switch in the rear of the housing. All jobs within FastRIP must be cancelled and deleted. Perform a
complete start-up and initialization to resume operations.
IMPORTANT POINT
Any le that was printing or spooled at the time of the emergency shutdown will be
lost. An unnished image cannot be restarted and all jobs must be re-spooled.
Kill Switch - Blazer PRO
The T-Jet Blazer Pro is equipped with a Kill Switch in both the Home and Index positions. These circuit
breakers will only be activated if the Printer Assembly attempts to exceed specic printing dimensions.
These switches will prevent damage to your machine should the Assembly fail to trip specic sensors.
In the event you experience a sudden and total loss of power to all systems, including the User Interface,
it may be due to a Kill Switch activation. To reset your system please do the following:
Turn OFF power to your machine by ipping the breaker switch located next to the AC power cord.
1.
If you do not turn OFF the breaker, the Printer Assembly may immediately activate the Kill Switch
again after reset.
Move the Printer Assembly 3-4” toward the center of the Platen.
2.
Reboot your system and power ON your printer.3.
IMPORTANT POINT
Should you experience a Kill Switch activation, all spooled les and print jobs must
be reloaded and again sent to Print.
A Warning About Page Sizes
When printing, you MUST ensure the correct Page Size is used. The Maximum Printable Area is limited
to the specications mentioned earlier in this chapter . FastARTIST comes with a template that matches
each dimension layout and we STRONGLY recommend you use these when printing. If you are printing
from a graphics application other than FastARTIST, you MUST make sure that you have congured your
Custom Page Size correctly within that program.
Failure to follow these guidelines could result in a blown fuse on the Main Board of your printer,
rendering it unable to print. Should this occur, you must contact Tech. Support for further instructions.
Height Sensor: Blazer Express ONLY
The Blazer EXPRESS (only) is equipped with a built-in Height Sensor that will help determine what the
height of the platen needs to be set to for printing. The height sensor is a thin laser beam that extends