User`s manual

T-Jet Blazer Series User’s Manual
Version 5.0 Revised September, 2008
90
Send the Print command (from FastARTIST).13.
After all Print Modes have been •
selected, select File>Print to FastRIP The print preview window will open (you may already have
this window open if you set the le up in this window).
Using the Arrow tool, select the art on the Artboard that you wish to print. In most cases you will
•
want to print everything on the Artboard. Drag a box around the entire image to select it then either
drag the art to center it in the preview window or using the arrows on the keyboard, adjust the
location as desired.
• Press the print icon in the FastARTIST
Print Toolbox.
The job will then be placed in the FastRIP Queue Window. Wait for the job to be spooled,
then right-click on the job and select print (you can set FastRIP to print automatically or Spool
only). Once the job reads “Printing”, continue to next step.
Press the Send Print Buttons.
14.
The Green button(s) on the User Interface will be blinking. Press and hold for a few seconds to begin
printing your image.
WARNING:
DO NOT press the Green button(s) on the User Interface until a job has been sent
and reads “printing” in the Rip Queue window. If you press the button too early, it
can result in serious printer errors and possible ruined garments.