User`s manual

Chapter 10 - Printing Basics
89
From the File Pull-down Menu, select FastRIP Setup. A window will open up letting you adjust all of
the print setting and Print Modes. You can also do this by selecting File>Print to FastRIP. The screen
will look a bit different and at the top of the window, click the square button with 3 dots in the
middle.
Pressing this button will open up the setup options.
All designs are different and each have different needs. A brief overview of Print Modes follows. For
a detailed listing of available Print Modes and their recommended usage, please refer to Chapter 7 of
your FastARTIST User’s Manual.
We recommend that you do ALL of your printing through FastRIP and
FastARTIST, even if you are NOT using White ink. After completing your
design in other graphics applications, Import that design into FastARTIST and
use the provided template for optimal printer performance.
12. Set UI to Auto Mode (for Printing) and Select Passes
On the User Interface, scroll through the screens until you
reach the Mode Select interface. Make sure that the Mode
Select dial is set to Auto. Also, select the number of passes
you wish to make by pressing the appropriate virtual
button. Note: You would select the number “2” if you are
using a two pass print mode or printing a white underbase.
The above photo shows how the Print Mode selection windows will look if you
print directly from Adobe Photoshop. (You MAY NOT have the same Print Modes
available with your version of the Fast T-Jet Blazer Express or PRO.)
How Print Mode selection will look if you print using FastARTIST.
(You MAY NOT have the same Print Modes available with your
version of the Fast T-Jet Blazer Express.)