User`s manual

Choose a Print Mode. (For a list and description of the available Print Modes, 3.

please refer to your FastARTIST User’s Manual.)

Print to FastRIP.4.

Finish with Fast T-Jet Non-Textile Post-Treatment

Fast T-Jet Non-Textile Post-Treatment is a protective coating used for prints on

non-textile surfaces. This post treatment will prevent fading of ink colors, extend

thelifeoftheimageaswellaswaterproongandactingasaUVprotectant.

DIRECTIONS:

Shake the can before each use and apply to non-textile, printed

surfaces only after all ink has dried thoroughly. Apply a thin coat,

holding the can 4 to 8 inches from surface and using a swift motion

to prevent overspray and unwanted build-up. If build-up does

occur, use a lacquer thinner to remove. A second coat may be

applied after approximately two minutes of drying time. Allow

treated surfaces to dry for 30 minutes to one hour in a clean, dust

free area before handling. Allow 24 hours cure time prior to placing

coated articles into service.

Clean the valve after use by turning the can upside down and spraying a

short burst until cleared. If the nozzle is clogged or sprays irregularly, check for

clogging within the opening. Scrape off excess coating with a soft object and

twist the valve one half turn to close.

Fast T-Jet Blazer Express User’s Manual