User`s manual

LaythegarmentontheShirtboard,stufnganyexcessintothespace•

between the top and base.

DO NOT leave a collar or seams exposed on top of the Shirtboard •

because the Print Head may strike this when printing. Load the collar over

thesoitsoutoftheway.Itisalsocriticalthattheshirtlayatandthatyou

always maintain a 3mm clearance between your garment and the Print

Head.Anyuctuationsintheprintingsurfacecouldcausetheprinttobe

soft or out of register and/or result in a damaging Print Head strike

Choose the artwork you wish to print. 3.

You can print directly to FastRIP from your

favorite graphics application (if you are not

outputting an Underbase or Highlight White), or

you can print from within FastARTIST.

Ensure the image is the correct size and that

you have placed it in on a “Page” that is the

same size as the printable area.

The easiest way to get the correct print

placement is create a template for the size

and placement of the Shirtboard or use

FastARTIST and load a pre-made Template.

(Remember, you MUST use FastARTIST if you will

be printing with White ink. Refer to Chapter 7 of

this Manual and Chapter 9 of your FastARTIST Manual for more details.)

The Blazer Express will support a total printable area of 16” x 20” (41 cm x 51

cm).

Important Point

FastARTIST refers to its page dimensions in terms of width and “height.” For

purposes of printing a two-dimensional image on a garment or non-textile item,

be aware of the fact that “height” means the same thing as “length.”

FastARTIST Page Size – Go to Layout > Page Size

FastRIP Setup – Within FastARTIST go to File > FastRIP Setup

Chapter 6- Printing with the

Fast T-Jet Blazer Express