User`s manual

Fast T-Jet Blazer Express User’s Manual

Pictured below are the various sizes of the Shirtboard available to meet your

printing needs:

All Shirtboards are comprised of a foam rubber pad atop a steel

base. Although the base is nearly indestructible, the rest of your

printer is not. DO NOT set anything atop the Print Bed. IT IS NOT A

STORAGE SHELF and it WILL WARP.

DO NOT apply any cleaner or glues to the foam rubber pads, they

will crumble and disintegrate, leaving a mess on your shirts. The

storage cabinets beneath your printer are provided for your

convenience to help you store shirts, inks, etc.

Here are the steps for printing:

Flip the Power Switch to ON and allow the machine to go through its different 1.

motionsandclickstogetthePrintHeadpositionedandinkowing.When

completed, ensure the Express in Print Status (The LCD Display MUST read

Paper Out/Roll Cut- refer to page 23 for more details.)

Load your shirt(s). 2.

Shirts can be full of lint and some •

have more than others. Lint is NOT

your friend. It can settle on key

components inside the Fast T-Jet

Blazer Express, affecting print quality

and printer operation. For better

results, grab a shirt by the shoulder

seams and snap it like you would a

small dusty rug before you place it

on the Shirtboard. This will actually

help pull out wrinkles as well. For the best results, use a Heat Press to heat and

attenthegarmentandgarmentbersbeforeloading.

Sleeve

Youth Standard Over-Sized