User`s manual

FastPOSITIVE, available from U.S. Screen. Otherwise it’s
difculttoseeWhiteinkonWhitepaper.Toinitiatea
Nozzle Check:
Take the printer from 1. Print to “Ready (Sheet)”
status by pressing the LEFT ARROW button twice.
The LCD display will read “Ready” and you will
see a “sheet of paper” icon. Only when in “Ready
(Sheet)” status can the Printer Assembly be
moved.
Usingthe“RIGHThand”button,shufethroughtheUIscreensuntilyougetto2.
the Mode Select screen. Ensure the virtual dial is set to Manual.
Press the “RIGHT hand” button on the UI again until you reach the 3. Manual
Mechanism Movement Utility (MMMU) screen.
PlaceyoursheetoflmorpaperontheShirtboard,takingcaretoalignthe4.
lmorpaperwiththeShirtboard’slowerrighthandcorner(asyoufacethe
front of the printer.)
Under the heading 5. Position, press the Index button. This will move the Print
Bed to the proper position for printing.
You must now change the printer mode to “Ready (Roll).” Press the LEFT 6.
ARROW button on the LCD Control Panel twice. The display will read “Ready”
with a “roll of paper” icon.
On Control Panel, press the RIGHT ARROW once and the display will read 7.
“Printer Setup.” Press the DOWN ARROW once to see “Test Print.”
Press the RIGHT ARROW button once to see “Nozzle Check.” Press the RIGHT 8.
ARROW again and “Print” will appear in the display.
To execute the Nozzle Check, press the RIGHT ARROW button once.9.
If the • Nozzle Check does not print correctly, perform a regular Head
Cleaning. This is done by holding down the RIGHT ARROW button for 3
seconds. After the Head Cleaning has been completed, execute another
Nozzle Check.
If, AT ANY TIME, you have performed three Nozzle Checks without
rebooting your printer, you must power OFF your printer before
executing another one.
Once you have obtained a satisfactory Nozzle Check press the Power OFF
26
Fast T-Jet Blazer Express User’s Manual