User`s manual

height for output. In addition, should you need to raise or lower the Platen to
accommodate different garments or other items, the following procedure
would be used:
At the UI, turn the printer OFF using the 1. Emergency button.
Turn the printer ON and allow it to go through a start-up cycle.2.
On the UI, press the “RIGHT hand” button until the 3. Mode Select screen
appears. (Refer to page 45 for details on UI screens)
In the upper left hand corner is a virtual dial pointing to “Auto.” Press the dial 4.
once and it will rotate to “Manual.”
Using the “hand” buttons, scroll through the UI screens until you reach the 5.
MMMU screen.
Press the 6. Jog button until the printer is over the Shirtboard.
Lift the printer cover if it is not already. Locate the Carriage Release button, 7.
press and manually move the Print Carriage until its sits near the center of
Shirtboard.
Use the Platen Height Adjustment knob to set a Print Head clearance of 8.
approximately 3 mm.
Slide the Print Carriage back to the capping station9.
Return to the UI and the 10. MMMU screen. Under the Position heading, press
Home.
You will hear an audible tone and the Printer Assembly will begin to move. When
it stops, it will be in the Home position
Perform a Nozzle Check
You must print a Nozzle Check to ensure the Print Head is performing properly.
Youmayuseeitherpaperorlmforthistest,butwerecommendlmsuchas
25
Carriage
Release Button
Chapter 4- Initialization Utilities