User`s manual

Fast T-Jet Blazer Express User’s Manual
24
until the LCD Display reads “Ready.”
Press the LEFT ARROW once more
and the LCD Display will read
“Paper Out” and display a “roll of
paper with scissors” icon.
The printer is now in Print status.
Whenever you need to get to Print status, this is the sequence
you will use. The only difference would be if you were preparing
to output an image onto a garment, the virtual dial of the Mode
Select Screen would be set to Auto.
Return the printer to “Ready” status by pressing the LEFT ARROW button •
once.
With the printer in • Ready status, press the RIGHT ARROW once.
Press the UP ARROW and scroll through the menu items until you come to •
“Maintenance.” Press the RIGHT ARROW once.
Press the DOWN ARROW to scroll the menu items until you come to •
“Power Clean.” To execute a Power Cleaning, press the RIGHT ARROW
once.
The LCD display will inform you of the Power Cleaning’s status in •
percentages. At the 10% mark, the display will prompt you to move both
blue levers adjacent the ink cartridges into the UP position.
At the 20% mark, you will be prompted to move both blue levers into the •
DOWN position. You will again be prompted to move both levers at the
30%, 40% and 50% marks. At the 50% point, both levers will be in the DOWN
position and you will not have to adjust them again during the power
cleaning cycle.
Once the Power Cleaning is complete, the LCD Display will read “Ready.”
Perform two more Power Cleanings.
Setting the Platen Height
It is necessary during setup to adjust the Print Bed (or Platen) to the proper
LCD Display in Print status aka “Paper Out
(Roll Cut)”