User`s manual

Final Unpacking Instructions

Removethepackingtapethatwasusedtosecurethelowproleaccesslid

and raise the cover.

DO NOT try to move the Print Carriage off of the Capping Station. The Fast T-Jet

Blazer Express locks the Print Carriage onto the Capping Station- forcing the Print

Carriage to move will damage your printer.

Note:Youmayndasmallamountofinkonthe

Waste Pad and/or Capping Station during setup. This

is normal and there is no need to be alarmed. Each

printer is run through a series of test print cycles before

shipping to ensure it is operating properly.

Release the Green shipping tab lock located at the base of the Print Carriage.

Plug the Unit into AC Power

Plug the printer into its own power source. The Fast T-Jet Blazer Express has a dual

voltage power converter built in, allowing it to work with 50 or 60 cycle current

ranging from 110 volts to 220 volt.

DO NOT TURN THE PRINTER ON YET! YOU MUST FIRST INSTALL THE BULK INK SYSTEM.

Insert the AC cord into the unit and plug the opposite end into a power strip with

surge protection. Avoid plugging multiple items into the same power strip.

For more reliable results, plug the unit into a UPS (Uninterruptible Power Supply)

tohelppreventruinedshirtsduringpoweructuations.DONOTplugotherhigh

power use items, such as a Heat Press, into the same circuit.

Powering Your Printer ON and OFF

When turning ON your Fast T-Jet Blazer

Express,youmustrstturnontheMain

Power Switch (located adjacent the AC

cord). Wait until the virtual LED labeled

“Automatic Mode” becomes Red and

then press the Power On (Orange) button.

This takes approximately 5 seconds.

Chapter 2- Unpacking and Setup

The virtual LED turns Red after 5 seconds