User`s manual

Causes:
Ink is not owing from the Bulk System.•
Ensure the breather hole in the cap of each ink cartridge has not
becomecloggedorclosed.Thecartridgesneedtobreatheasinkows
through the lines.
Ribbon cable to the Print Head is damaged.•
Ifyouaccidentallysplash/dripinkorcleaninguidonthegrayribboncable
that connects to the Print Head, it can short out. Check for burn marks on
the ribbon cable connectors. Check to make sure it hasn’t been crimped or
pinched.
Motherboard is bad.•
There is a chance the motherboard is bad. The board could have a defect
orsomeuidmayhavebeenspilledonit.Ifinkorcleaninguidrunsdown
the ribbon cable and drips into the bed it can short out the motherboard.
Capping Station Clogged. •
The Capping Station may need cleaning. If the Print Head did not seat
properly, ALL of the nozzles could be clogged.
Problem:
The image is printing outside of the shirtboard or in the wrong location.
Causes:
You have a mismatch in the software settings.
Make sure your working Page Sizematchesthenalprintpagesize.Acommon
error is working on one Page Size in a graphics program but printing to a
different Page Size in FastRIP.
Problem:
Modifying Factory Default printer settings.
Causes:
Theprinter’sdefaultsettingshavebeenconguredbyU.S.Screenpriorto
shipping, however, here is a list of the Printer Setup Menu Modes. DO NOT
deviate from these settings.
Ifyoundanincorrectsetting,youMUSTcontactCustomerSupportBEFORE
making any changes.
105
Chapter 11- Troubleshooting