User`s manual

FastARTISTusesitsownICCProle-makesureyoudonotapplyonefromyour
preferred graphics program. Refer to your graphics
application’sUser’sManualonICCproles.
You have an ICC prole checked in CorelDRAW.•
Go to File > Print and select the Misc. Tab. Uncheck Apply ICC Prole.
The Capping Station is not working properly.•
Clean the Capping Station.
Prevention:
Usually when a color prints with an incorrect hue, it is because a Nozzle is
clogged. If you are trying to print an Orange image but it appears more Yellow,
that means the Magenta is clogged and the pigments can’t mix to produce
Orange.
The most important part of your Fast T-Jet Blazer Express is the Capping Station.
Make sure this ALWAYS stays clean. The Print Head “docks” here when not in use
to
ensure it does not dry out. The Capping Station is also used during Head
Cleanings. If the Capping Station is dirty, the printer can’t do a proper Head
Cleaningandxacloggednozzle.
Note: When building any image inside any software program, make sure you
always use RGB color mode because this is how your monitor displays colors.
NeverapplyanICCprole.
Problem:
Prints are out of alignment or there are large gaps in the print.
Causes:
Different Print Modes are being used•
Double-check settings in the FastRIP Setup screen and make sure all Print
Modes are of the same type. If using an HS Print Mode for the
color then the same Mode must be used for the Underbase (i.e. Photo 720
Standard HS Print Mode and 1440 DPI Image Normal Underbase HS).
Encoder strip is dirty and needs to be cleaned•
Clean the Encoder Strip.
If using an Underbase and/or Underbase wizard, the Black and White versions •
of images may be different sizes.
Double check the images’ Heights and Widths to make sure they are
identical.
Print Carriage is jumping around and causing a misread of the Encoder Strip.•
Clean the Drive Belt Gear.
98
Fast T-Jet Blazer Express User’s Manual