Operator`s manual

TTM 57SL FOR SERATO SCRATCH LIVE • OPER ATOR’S MANUAL 1.9.2
32
HI-FI RESAMPLER
This signicantly reduces digital distortion at very
slow or very fast record speeds, increasing the
CPU load slightly. This option is off by default,
the old resampler is used when switched off.
PLAY FROM START
Enable this to start all tracks from the beginning
when loaded in rel and int modes. If this setting
is not enabled, freshly loaded tracks will continue
to play from the point the last track was at. This
option is on by default.
INSTANT DOUBLES
This allows you to quickly match the playhead
position of two tracks. With this option set,
when you load a track on one virtual deck that is
already loaded on the other virtual deck (it must
be the same le), the playhead will jump to the
position of the track that was loaded rst, with
the keylock state and looping settings copied.
This setting overrides the play from start and
play from rst cue point options.
PLAY FROM FIRST CUE POINT
Enable this option to start all tracks from the rst
cue point when loaded in rel and int modes. This
setting overrides the play from start option.
BRAKING
In internal mode, this controls how fast the deck
stops when play is stopped. Counter-clockwise,
the stop is immediate. Clockwise rotation
increases the stop from a nger grab all the way
to a slow turntable power-down.
AUDIO OUTPUT
By default the output of Scratch Live is stereo.
You can also select mono output. This setting is
saved when you exit Scratch Live.
VINYL CONTROL
ADJUST LOOPS WITH VINYL
Loop end points can be adjusted using the
control vinyl. Disable this option if you wish to
use the computer’s arrow keys to adjust loops,
and keep audio playback controlled by the vinyl.
SEE “LOOPING” ON PAGE 20.
NEXT SONG ON FLIP
When this option is enabled, changing the
side of control vinyl you’re using (‘ipping
the record’) loads the next song, as with
the Autoplay function. SEE “PLAYBACK
CONTROL” ON PAGE 15.
ENABLE VINYL SCROLL
Uncheck this box to disable the Vinyl Scroll
feature. SEE “VINYL SCROLL” ON PAGE 15.
REVERSE VINYL SCROLL
This setting allows you to reverse the direction
of Vinyl Scroll. SEE “VINYL SCROLL” ON PAGE 15.
VINYL SCROLL SPEED
Vinyl Scroll allows you to load a new track
without touching the computer, simply by lifting
the needle and placing it in the special section of
side A of the control record. This setting allows
you to adjust the sensitivity of Vinyl Scroll, so that
you can control the amount of record movement
required to move between tracks.
DROP TO ABSOLUTE POSITION
This detects a deliberate repositioning of the
needle, and moves the playhead to the absolute
position of the needle, as in absolute mode.
Accidental skipping of the needle does not
reposition the playhead.
DROP TO CUE POINTS
This option triggers the corresponding cue point
when the needle is repositioned into one of the
rst 5 one-minute sections on the control vinyl.
For instance: needle dropping into the second
minute on the left turntable, will send playback
for deck 1 to cuepoint 2, if that cuepoint is set.
VINYL START OFFSET
If you nd that you have cue burn at the beginning
of the record, you will notice that the tracking will
be poor at this point. Use the two knobs to offset
the start point, so that the track will start playing
from a point further into the control record. The
rst knob sets the number of whole minutes to
offset by, the second knob sets the number of
whole rotations within that minute.