Specifications

Page8
2 TAG Specifications
Product Model/Name
Product Name - AMUT03 – Cow Monitoring Neck TAG
Model 1 – HR-TAG-LDn
Model 2 – cSense Flex
Model 3 –Monitoring Neck Tag Flex
The difference between models is SW and enclosure color ONLY.
2.1 General description
A neck TAG mounted on a collar on the animal neck, used for the following:
1. Identification of animal using 2.4GHz transceiver and optical IRDA receiver
and/or NFC reader unit.
2. Measure various animal parameters, processes and transmit them via 2.4 GHz to
the base unit (BU500/E) and/or local IDUxx.
The TAG initiates transmissions of few messages each hour by predefined sequence or
upon request from IDUxxx via IRDA receiver or BUxxx/SenseHub units via the 2.4GHz
link.
Outdoor installation, sealed unit, powered from the internal 3.6V battery.
2.2 2.4GhZ Transceiver Parameters
RF Transceiver: Atmel AT86RF233
RF Frequency: 2.405-2.48GHz
Modulation type: QPSK
RF Channels: 5MHz separation 16ch (2.45MHz Occupied Bandwidth)
Baud Rate: 250K Bit/Sec (Not configurable)
Output power: 7.5 dBm (Max)
Antenna type: PCB Omni-directional
Antenna gain: Average 0dBi (Max gain: 1.5dBi)
Average RF data: 3 messages/hour, 1mSec/message, ~30bytes/message.
2.3 Optic Parameters
IRDA Receiver – using to initialize TAG parameters and ID transmission via the 2.4GHz link an
aim to identify specific animal in a specific location as milking station or passing gate.