Replacement Part List

6
Wing nut
16
Tine assembly, C
7
J-bolt M6
17
Tine assembly, B
8
Center handle section
18
Tine assembly, A
9
Lower handle section - II
19
Tine lock pin
10
Lower handle section - I
20
Wheel
4
Model TC70105S
ASSEMBLY
This product must be assembled correctly before use.
1. Remove the screws (M5 X 12) and washers from 4. Slide the cord retainer onto the center handle
each end of the wheel frame axle. Assemble the section. (Fig. 2-3) wheels onto the axle, then
install washers and 5. Attach the center handle section to the lower handle screws (M5 X 12) to
secure. (Fig. 2-1) sections using the two supplied M6 J-bolts and wing
2. Press the hub caps into the wheels and cover the nuts. (Fig. 2-4) ends of the axles. You may use
a hammer to seat 6. Fasten the upper handle section to the center handle them securely into the
wheels. (Fig. 2-1) section using the two supplied M6 J-bolts and wing
3. To lower wheel frame, push the lock button on back nuts.(Fig. 2-5) of motor housing to release the
frame (Step A). 7. Use the two supplied cable clips to secure the cord to