Operator`s manual

Service Engine - 24
SERVICE ENGINE
Service Engine
Engine Warranty Maintenance Statement
Maintenance, repair, or replacement of the emission control
devices and systems on this engine, which are being done
at the customers expense, may be performed by any non-
road engine repair establishment or individual. Warranty
repairs must be performed by an authorized John Deere
dealer.
Avoid Fumes
Engine Oil (Gas)
Use oil viscosity based on the expected air temperature
range during the period between oil changes.
The following John Deere oils are preferred:
• TURF-GARD®
• PLUS-4®
Other oils may be used if above John Deere oils are not
available, provided they meet the following
specification:
• API Service Classification SG or higher
Checking Engine Oil Level
NOTE: Check oil twice a day if you run engine over 4
hours in a day.
1. Park machine safely. (See Parking Safely in the Safety
Section.)
2. Lift hood.
3. Clean area around dipstick to prevent debris from falling
into crankcase.
c
CAUTION: Avoid injury! Engine exhaust fumes
contain carbon monoxide and can cause
serious illness or death.
Move the vehicle to an outside area before
running the engine.
Do not run an engine in an enclosed area
without adequate ventilation.
• Connect a pipe extension to the engine
exhaust pipe to direct the exhaust fumes out of
the area.
• Allow fresh outside air into the work area to
clear the exhaust fumes out.
IMPORTANT: Avoid damage! Failure to check the oil
level regularly could lead to serious engine
problems if oil level is low:
• Check oil level before operating.
• Check oil level when the engine is cold and not
running.
• Keep level between the FULL and the ADD marks.
• Shut off engine before adding oil.
SAE 10W-40
SAE5W-30
SAE 10W-30
122° F
104° F
86° F
68° F
50° F
32° F
14° F
-4° F
-22° F
-40° F
50° C
40° C
30° C
20° C
10° C
0° C
-10° C
-20° C
-30° C
-40° C