Prizelawn CD36C ® COMMERCIAL DROP SPREADER MODEL CD36C OWNER’S MANUAL
Assembly Instructions 3/16 X 2” Cotter Pin Handle Brace Leg Nut 1/4-20 X 1/2” Hex Bolt Lock Washer Drive Wheel 1. Remove spreader and components from carton. 2. Slide Wheels onto each end of Axle with Place Hopper on it’s front panel, insert two (2) 1/4-20 X 1/2” Hex Head Bolts through the Leg, flattened end of Handle Brace, and holes in Hopper as shown. Install Lockwashers and Nuts but do not tighten. Repeat on opposite side. the longer portion of the Wheel facing the Hopper.
Operation 1. Before filling Hopper, make sure spreader 4. Operate spreader at 3 MPH pace. Handle Lever is in the “OFF” position. Always fill spreader on walk or drive, not on the lawn. (33.3 feet in 7.5 seconds) 2. Loosen Rate Control Knobs and move the Tie Bar to setting recommended for the product applied. If PrizeLAWN settings are not available, use Scotts® drop spreader settings. If setting is not known, refer to “DETERMINING APPLICATION RATES” section of this book.
Parts List for Model CD36C 19 24 15 20 24 18 21 17 14 16 13 12 1 22 2 11 3RH 4 6 7 9 10 ITEM 1 2 3 RH. 3 LH. 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 PART # 14211-1 14414-2 14643-1 14644-1 14231 14235 14227 14007 14222-1 90005 14006 15032 12714 12704 14237 14286 12708 15029-1 15046 14047 14870 14415-1 14409 15066 14236 — 15063 5 8 DESCRIPTION HOPPER ASSEMBLY SHUTOFF BAR ASSEMBLY* AGITATOR/AXLE ASSEMBLY-LH. * AGITATOR/AXLE ASSEMBLY-RH.
