User manual

9. Slide the unit into the sleeve until it locks into place.
Ensure that you install the short part of the threading to the back of the unit and the long part to the metal strap.
10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's
front panel (see the steps of ' ').
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery's negative (-) terminal.
2. Press the ( ) button to remove the front panel.
3. Lift the top of the outer trim ring then pull it out to remove it.
4. Insert both of the supplied keys into the slots at the middle left and right sides of the unit then pull the unit out of the
dashboard.
5. Remove the metal strap attached to the back of the unit (if attached).
TO ATTACH THE FRONT PANEL
Dismantling the unit
OPEN
GB-6