User manual

Symptom Cause Solution
No power
The car ignition switch is not on.
Turn the ignition key to “ACCESSORY” in order to switch the unit on.
The fuse at the back of unit has been
blown.
Check the connections.
Presence of CD disc inside the player.
Remove the disc from the player, and insert a new one.
Disc can not be loaded
or ejected.
Inserting the disc in reverse direction. Insert the CD with the labe facing upward.l
The surface of CD is extremely dirty or
scrapped.
Clean the disc or try to replace a new one.
Temperature inside the car is too
high.
Cool off or until the ambient temperature return to normal.
Condensation
Leave the player off for an hour or so, and then try again.
No sound Volume is in minimum
.
Adjust volume to a desired level.
The wiring is not properly connected.
Check wiring connection.
Sound skips
The installation angle is more than 30 .
0
Adjust the installation angle less than 30
0
.
The surface of CD is extremely dirty or
scratched.
Clean the disc or try to replace a new one.
The operation keys do not
work
1. The built-in micro-processor is not
operating properly due to electrical noise.
2. The front panel is not properly
installed.
1. Press the RESET button.
2. Fix the front panel into its place.
No radio reception. The antenna cable is not connected. Insert the antenna cable firmly into the antenna socket of this CD player.
In automatic search mode
the radio does not stop at
a transmitting station.
The transmission signals are too weak.
Select a radio station manually.
GB-25
TroubleShooting
The connections are not correct.
A fuse has blown in the vehicle
Check the vehicle fuses.
Check the antenna connection.