User manual

Reset the unit
Power on/off
1.Turn off the unit power.
2.Press the ( ) button and remove the front panel, then press the button with a ballpoint pen or similar object
to restore the unit to the original factory settings.
In power off mode, switch on the unit by pressing any button except the button and the ( ) button or inserting a
disc into the slot When the system is on, press the ( ) button to turn off the unit.
OPEN RESET
OPEN EJECT
. POWER
Sound adjustment
System setup menu
-
-
In each mode, w
“TA SEEK or TA ALARM” “PI SOUND or PI MUTE” “RETUNE L or RETUNE S” “MASK DPI or MASK ALL”
Note:
gg g g
When operating the unit for the first time, after replacing the car battery or changing the connections, you must reset the unit.
Rotate the volume/select button to adjust volume level.
- Press the volume/select button repeatedly to select the sound setting that you would like to adjust: volume, bass, treble,
balance or fader. Rotate the volume/select button to adjust the level of the selected sound mode:
VOL: from 00 to 100 (50 levels)
- BAS (bass) / TRB (treble): from -10 to +10
- BAL (Balance): 10L, 9L, ~,L=R, ~, 9R, 10R. Note: L = left,R=right.
-FAD(Fader):10F,9F,~,F=R,~,9R,10R.Note:F=front;R=rear.
Press the volume/select button and hold for more than 2 seconds to access the system setup menu mode, then press the SEL
button to select the menu item in sequence as follows:
“BEEPS 2 , BEEP ALL, BEEP OFF”
After selecting the desired menu item, rotate the volume/select button to make the adjustment.
ND
hen the unit has not been adjusted for about 5 seconds, the current setting will be saved and it will return to
the previous mode.
General Operations
GB-10