User manual

GB-5
10. Reconnect the cable to the vehicle battery’s negative (-) terminal. Then replace the outer trim ring and install the unit’s front panel
(see the steps of ‘Installing the front panel’).
Removing the unit
1. Make sure the ignition is turned off, and then disconnect the cable from the negative (-) terminal of the vehicle’s battery.
2. Press the REL ( ) button to remove the front panel.
3. Remove the top of the outer trim ring by pulling it out.
4. Insert both of the supplied keys into the slots at the middle of the left and right sides of the unit then pull the unit out of the
dashboard.
5. Disconnect the wire harness and the antenna, and disassemble the metal bar attached to the back of the unit (if present).