MCX32 CD/MP3 CAR RADIO WITH MANUAL TUNING AND RDS FUNCTION AM/FM STEREO RDS FUNCTION (AF/TA/PTY) PLAYS MP3/ID3 TAG FILES RECORDED ON CD-R/CD-RW USB PORT & SD/MMC CARD SLOT ON FRONT PANEL ANTI-THEFT DETACHABLE FRONT PANEL MUSIC POWER: 28 WATT USER MANUAL AND INSTALLATION INSTRUCTIONS
Contents ACCESSORIES....................................................................................................................................................................................GB-1 SAFETY.................................................................................................................................................................................................GB-2 1. INSTALLATION........................................................................................
ACCESSORIES Mounting Bracket (Half Sleeve) X1 Tapping Screw X1 Outer trim ring X1 Screw X4 Small Metal Strip X1 Hex Nut X1 Plain Washer X1 Release key X2 Spring Washer X2 ISO Wire connector X1 MCX32 AM/FM STEREO RDS FUNCTION (AF/TA/PTY) PLAYS MP3/ID3 TAG FILES RECORDED ON CD-R/CD-RW FRONT PANEL USB PORT & SD/MMC CARD SLOT ANTI-THEFT DETACHABLE ON FRONT PANEL MUSIC POWER: 28 WATT USB Adaptor Cable X1 Removable control panel X1 Protective case X1 GB-1 User manual X1
SAFETY This unit is designed and manufactured with the users safety in mind, however any improper use or operation may result in certain dangers. It is therefore highly recommended to read this manual thoroughly and adhere to the following precautions. Safety precautions * To prevent an electrical shock, do not open the housing of the unit. In any case of malfunctioning, only have the unit serviced by an approved and qualified service centre. * Do not expose to any water or to a very humid environment.
1. INSTALLATION Notes: - Before the installation of the unit, make the electrical connections and ensure everything is connected properly and that the unit works correctly. - Consult your dealer if installation requires the drilling of holes or other modifications of the vehicle. - Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop. - If installation angle exceeds 30° from horizontal, the unit may not perform properly.
4. If necessary, remove the outer trim ring. 5. The two supplied keys release tabs inside the unit’s sleeve so you can remove it. Insert the left (“L”) and right (“R”) release key as far as they will go (with the notches facing up) into the appropriate slots at the center of the left and right sides of the unit. Then slide the sleeve off the back of the unit. 6. Fit the sleeve by inserting it into the opening of the dashboard and bend back the tabs located around the sleeve with a screwdriver.
10. Reconnect the cable to the vehicle battery’s negative (-) terminal. Then replace the outer trim ring and install the unit’s front panel (see the steps of ‘Installing the front panel’). Removing the unit 1. Make sure the ignition is turned off, and then disconnect the cable from the negative (-) terminal of the vehicle’s battery. 2. Press the REL ( ) button to remove the front panel. 3. Remove the top of the outer trim ring by pulling it out. 4.
2. USING THE DETACHABLE FRONT PANEL 2.1 Removing the front panel Press the REL ( ) button on the front panel. Pull off the front panel. Place the front panel into the protective case provided. Fig.1 Fig.2 Fig.3 2.2 Installing the front panel First, fit the left side of the front panel and then fit the right side of the front panel until you hear a click sound. If the panel is not properly fixed in the unit, some of the keys or the display may not function properly.
3.
1 4. OPERATION 2 4.
4.2 General Operation 4.2.1 Turning the unit on/off Turn on the unit by pressing any button (except the REL ( ) button or EJECT ( ) button) or by inserting a disc in the DISC SLOT, or inserting an SD/MMC card into the card slot or a USB device into the USB port. Press the VOL+/- buttons to adjust the volume level. When the unit is on, press the POWER button to turn off the unit. 4.2.
- When receiving an RDS station In RADIO mode: Name of the station FREQUENCY In DISC, USB, SD/MMC or AUX mode: Name of the station FREQUENCY PTY CLOCK PTY CLOCK FUNC - When receiving a non-RDS station In RADIO mode: Frequency (NO PTY) CLOCK In DISC,USB, SD/MMC or AUX mode: FREQUENCY (NO PTY) CLOCK FUNC Note: - PTY: Programme Type - The name of the station and the type of programme or the message “NO PTY” (no programme type) only appears on the LCD screen if you select the FM band. 4.2.
unit skips due to rough road conditions, the music will be uninterrupted. The time of the memorised content varies depending on the disc type: CD: 40 seconds; MP3: 120 seconds See section 4.2.2 “SEL button function” to the ESP function on/off. 4.2.10 LED anti-theft indicator The LED indicator will flash if the unit is connected to a power supply. 4.2.11 Reset function Use the RESET button in the following cases: - Initial installation of the unit when all wiring is completed.
4.4. RDS (Radio Data System) Operation RDS allows FM broadcast stations to emit an additional signal along with the ordinary FM radio signal. For example, the stations can emit their station name, as well as information about what type of programme they are broadcasting. 4.4.1 AF function This function allows the user to find out the list of alternative frequencies available.
4.5.4 Introduction scan Press the SCN button to play the first several seconds of each track on the current disc. Press it again to stop the introduction scan and listen to the music. 4.5.5 Repeating the same track Press the RPT button to set the unit to repeat the same track. Press it again to stop the repeat function. 4.5.6 Playing all tracks in random Press the SHF button to play all tracks on the disc in random order. Press it again to cancel this function. 4.5.
3) Searching from root directory In this search mode, the list of directories and tracks appears on the LCD display. a). Press the VOL+/VOL- buttons to browse through all the directories or files in the root directory. b). Press MOD(ENTER) to select. Play the song if the selected title is a file. If the selected title is a directory, repeat the above steps. 4) Searching from current directory In this search mode, the list of sub-directories and tracks in the current directory appears on the LCD display. a).
4.5.8 Supported MP3 decoding modes The MP3 decoder in this unit supports the following formats: Standard Bit Rate (kbps) Supports mode MPEG1 AUDIO Layers 3 (44.1KHz) 32,48,64,96,128, 192,256,320 Stereo 4.6 USB device and SD/MMC card Operations - Playing MP3 files on the USB device or SD/MMC card: When you insert a USB device into the port or an SD/MMC card into the card slot, the unit will search for the MP3 files and start to play them automatically.
5. DISC NOTES 5.1 Notes on discs a. Do not use non-standard shape discs (e.g. square, star or heart-shaped discs) as they may damage the unit. Be sure to use circular CD discs only for this unit. b. Do not stick paper or tape, etc, onto either side of your discs, as it may cause a malfunction. Dusty, scratched and warped discs may cause problems in playback. 5.2 Notes on CD-Rs/CD-RWs a. Be sure to only use discs with following marks: b. The unit cannot play a CD-R or CD-RW that has not been finalized.
- Do not expose discs to direct sunlight or place them in dirty, dusty or damp areas. Do not store near the heater vent of your car, or leave on the seats or dashboard. 2) Disc cleaning Use a dry soft cloth to wipe the surface. If the disc is quite dirty, use a soft cloth, lightly dampened with isopropyl alcohol. Never use solvents such as benzene, thinner or conventional record cleaners as they may damage the surface of the disc. 5.4 Precautions when using new discs A new disc may have rough edges.
6. TECHNICAL SPECIFICATIONS GENERAL Pow er Supply Requirements DC 12 Volts, Negative Ground Unit Dimensions 178(W) x 160(D) x 50(H) mm Tone Controls - Bass (at 100 Hz) ±14 dB - Treble (at 10 KHz) ±14 dB Maximum Output Power: 7W X 4 CH; Normal Output Power: 3.2 W (r.m.s.) x 4 CH Fuse: 10 Ampere (max.) Sensitivity: <38dB USB/SD/MMC (card) USB port type: 2.
7. TROUBLESHOOTING SYMPTOM The unit will not switch on Disc cannot be loaded or ejected. No sound. Sound skips. The front panel buttons do not operate properly. The radio does not work. CAUSE SOLUTION The +12V car ignition is not on. Turn the ignition key to the “Accessory.” position in order to power the radio. The fuse of the vehicle powering the unit has blown. Replace the vehicle fuse with a new one with the same capacity. The ISO harness is not properly connected.
