User manual

GB-4
INSTALLATION
Notes:
- Choose a mounting location where the unit will not interfere with the driver’s ability to drive the car.
- Before completing the final installation of the unit, connect the wiring and make sure that the unit works properly.
- Consult your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
- Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an
emergency stop.
- If the installation angle exceeds 30° from the ho rizontal, the unit may not perform properly.
- Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or a heat source. Also avoid
contact with dust, dirt and excessive vibrations.
Installation Opening
This unit can be installed in any dashboard that has an opening as shown below (DIN standard):
Installing the unit
1. Make sure the ignition is turned off, and then disconnect the vehicle’s battery.
2. Lift the top of the outer trim ring then carefully pull it out to remove it.
3. Use the two release keys supplied to remove the unit from the mounting bracket. Insert the left and right release keys so that they
release the left and right sides of the sleeve.
Then slide the sleeve off the back of the car radio.