Instruction manual

After setting the alarm time, the alarm mode option will flash. Select a source

using the buttons: Buzzer “ ”, “Radio”, “CD” or “iPod”. Press AL1 or

AL2 to confirm.

GB-4

Note:

Precautions when using batteries

BASIC OPERATION

ON/ Standby

Setting the clock

Using the alarm

Setting the alarm time

Setting the alarm mode

Enabling/ Disabling the alarm function

The remote control battery normally lasts for about one year, although it

depends on how often the remote control is used. If the remote control is not

working properly, replace the battery.

CAUTION: Danger of explosion if battery is incorrectly inserted. Replace only

with the same or equivalent type.

Do not mix different types of batteries together (e.g. alkaline, rechargeable and

standard (carbon zinc)) or old batteries with fresh ones.

Exhausted batteries must be removed to prevent possible leakage.

Dispose of batteries properly in accordance with the environmental regulations

in force.

When it is connected to a power supply (refer to “POWER SUPPLY”), the unit goes

to standby mode and the clock time is displayed. Press the ON/STANDBY button

to turn on the unit and press it again to go back to standby mode.

The unit allows you to wake up to the sound of the buzzer or to music

(Radio/CD/iPod).

In standby mode, press and hold down the MEM/CLK button and use the

buttons to select 24Hr or 12Hr display format. Press the MEM/CLK button

to confirm and set the clock.

Use the buttons to set the hour, and press the MEM/CLK button to

confirm.

Repeat step (2) above to set the minutes.

In standby mode, press AL1 or AL2 to display the alarm time. Then, press and

hold down AL1 or AL2. The hour digits will flash.

Use the buttons to set the hour.

Press AL1 or AL2 to confirm. The minute digits will flash.

Repeat steps (2) and (3) to set the minutes.

Press and hold AL1 or AL2 to enable or disable the alarm function.

When the alarm function is on, the buzzer or music will come on at the set time.

To stop the alarm, press the /AL OFF button. The alarm will sound again at

the same time the next day.

To disable the alarm function, press and hold AL1 or AL2.