Operation Manual

ENGLISHENGLISH
3. tighten the cable and fix the cablefixing screw
(S7) by turning it clockwise with a 2mm allen
key and a max. tightening torque of 1.6Nm.
4. Check that the handlebar lever
is in the traction position. Refer
to the following diagrams.
5. cut the cable approx. 20mm away from the
remote wheel. Fix it by squeezing it with pliers.
6. push a cable end-cap on the cable until it
touches the end of the cable. Fix it by squeezing
it with pliers.
•
BASIC SET-UP OF THE TWINLOC REMOTE CONTROL OF FOX
CTD SHOCK
The assembly of the remote cable and the setup of the FOX CTD rear shock is very similar to
the abovementioned assembly and setup of the FOX Nude.
For more details on the FOX CTD please follow the details shown in the manuals of FOX
attached to this bike.
•
RECOMMENDED TOOLS FOR THE SHOCK SET-UP
For the set-up of the shock we recommend to use a shock pump with a scale up to 20
bars/300 psi with a special air valve connector preventing from air getting away while
removing the pump from the shock valve, this will result in an exact air pressure.
Please note that air will flow into the hose and indicator when counterchecking the air
pressure, so you have to set up again the recommended pressure after this action.
Make sure to balance at least this air loss when you make a check of the air pressure of the
shock. Please also note that the indicators of shock pumps have a tolerance of max. 10%.
13 |
BIKE USER MANUAL | GENIUS LTGENIUS LT | BIKE USER MANUAL
| 12