Operation Manual

GENIUS LT | BIKE OWNER’S MANUAL 2015 BIKE OWNER’S MANUAL 2015 | G ENIUS LT

ENGLISH

SET-UP GENIUS LT WITH FOX NUDE OR FOX CTD SHOCK

The Set-Up of the FOX Nude or FOX CTD Shock can be easy done within a few

minutes.

IMPORTANT!

For all adjustments of the air spring the remote lever has to be in position “alltravel”

To adjust the air pressure of the air chamber of the FOX Nude or FOX CTD Shock

please refer to the following instruction:

1. Remove the valve cap of the valve (s5) located on the shock housing (S3).

2. Mount the shock pump with its adaptor on the valve

3. Please take into account that it takes some air pressure from inside the shock to

drive the indicator on the pump. Make sure to balance at least this air loss when

you make a check of the air pressure of the shock. Pls also note that the indicators

of shock pumps have a tolerance of max. 10%

4. Please use the FOX iRD App available at the iTunes App store with following link:

https://itunes.apple.com/us/app/fox-intelligent-ride-dynamics/

id549035102?mt=8&ign-mpt=uo%3D4)

5. After downloading the app on your mobile gear please follow the steps shown in

the app and inflate the shock according to the air pressure indicated.When you

reached the needed pressure remove the pump and put the valve cap on the valve

6. When you reached the needed pressure remove the pump and put the valve cap

on the valve

SAG

The SAG should be 18mm on the shock piston.

To check the adjustment, please follow as shown below:

1. sit on the bike, put your feet on the pedal

2. put your feet back on the ground and stand over the bike without bouncing the

bike during this action

3. check if the o-ring (S9) on the shock piston (S8) has a distance of 18mm to the

main dust wiper/seal between shock housing and piston.

- if the distance between the o-ring and the main dust wiper/seal is 18mm, the air

pressure is matching to your weight

- if the distance between the o-ring and the main dust wiper/seal is less than 18mm,

the air pressure of the air chamber is too high and should be carefully reduced by

using the bleed knob of the shock pump until the distance is 18mm.

- if the distance between the main dust wiper/seal is bigger than 18mm the air

pressure of the air chamber is too low and should be increased by using the shock

pump until the distance is 18mm.