Operation Manual

20 scott-sports.com 21
GENIUS
BIKE OWNER’S MANUAL
ENGLISH
The SAG should be 14mm (27.5/650B) respectively 12.5mm (29”) on the
shock piston.
To check the adjustment, please follow as shown below:
1. sit on the bike, put your feet on the pedal
2. put your feet back on the ground and stand over the bike without bouncing
the bike during this action
3. check if the o-ring (S9) on the shock piston (S8) has a distance of
14/12.5mm to the main dust wiper/seal between shock housing and piston.
- if the distance between the o-ring and the main dust wiper/seal is 14/12.5mm, the
air pressure is matching to your weight
- if the distance between the o-ring and the main dust wiper/seal is less than
14/12.5mm, the air pressure of the air chamber is too high and should be carefully
reduced by using the bleed knob of the shock pump until the distance is
14/12.5mm.
- if the distance between the main dust wiper/seal is bigger than 14/12.5mm the air
pressure of the air chamber is too low and should be increased by using the shock
pump until the distance is 14/12.5mm.
SAG
SET-UP OF REBOUND FOX NUDE OR FOX CTD
SHOCK
“Rebound” describes the speed the shock comes back to its original length
after absorbing an obstacle.
By using the rebound adjuster knob (S4) you can adjust the rebound step by step.