Operation Manual

REL
Note:
Never put any objects between the main unit and the front panel
DETACHING THE FRONT PANEL
Press
RELEASE button in the upper right hand corner, and then the front panel will be folded down.
When the front panel is turned down to a position of 9 0 ° , hold and slide the front panel to right, and then pull it out.
INSTALLATION OF THE UNIT
Take Out Screws Before Installation
Before install the unit, must remove the two screws with label “WARNING”.
Installation Method : DIN Front-Mount
Precautions
• Choose the location of the unit carefully so that the unit does not hinder the normal functioning of the vehicle.
• Before installing the unit, make sure that the front panel can move freely and can be easily removed.
• Do not install the unit in a location where it could be exposed to high temperatures, to direct sunlight, to hot air from the
heating system, to dust, dirt or excessive vibrations.
• For successful installation, only use equipment intended for this purpose.
• Be sure to remove the front panel before installing the unit.
• In order to avoid certain problems relating to disc playback, the unit must be installed at an angle of less than 30°.
GB-6