Operation Manual

Many vehicles are pre-fitted with ISO connectors behind the dashboard, including all the electrical cabling for a car radio. In such cases, the
connections fitted to the vehicle can be directly plugged into the car radio connectors. Should your car not be pre-fitted with these connectors,
we strongly advise you to obtain the ISO wiring loom fitted with the male connector for connection to your car radio either from a specialist
shop or from the car dealer for your vehicle. Once obtained, you will only need to connect your loudspeakers and the power supply to the ISO
connector, following the connection instructions below.
Power Supply Connector
1.Battery (yellow)
Speaker Connector
Power Supply Connector
5. Speaker Connector 10.Front left speaker + (white)
6.Rear right speaker + (violet) 11.Front left speaker – (white/black)
2.Ground (black) 7.Rear right speaker - (violet/black) 12.Rear left speaker + (green)
3.Power +12 volt (red) 8.Front right speaker + (grey)
13.Rear left speaker – (green/black)
4. Electrical Antenna (blue) 9.Front right speaker – (grey/black)
1) Make sure your car battery is a 12 volt (6 filter caps) negative ground system (if not, a converter will be necessary).
2) Before starting wiring connections, disconnect the power supply by removing the fuse from the fuse holder.
3) Connect the power wire to one of the extra terminal of the car.
4) Connect the black ground wire to a metal part of the car. It is important to make good contact.
5) Make other wiring connections as shown.
6) Connect the battery of the car.
7) Replace the fuse holder of the unit.
NOTE IN CORRECT WIRING OR OPERATION WILL VOID THE WARRANTY OF THIS UNIT.
GB-10