User guide

“SPDIF/OFF”: The audio signal is not transmitted via the “COAXIAL” or “HDMI” output. Select this
option when no digital output is used.
“SPDIF/RAW”: Dolby Digital signals are unaltered. Generally, this setting is used with a digital 5.1
channel receiver.
“SPDIF/PCM”: Dolby Digital and MPEG 2 multi-channel signals are converted to PCM (Pulse Code
Modulation). This setting is suitable for amplifiers or receivers without digital multi-channel sound
decoders.
Note:
• This unit does not support DTS decoding.
3.2 “KEY”
Use the ▲ or ▼ button to adjust the key tone.
4.VIDEO SETUP
Use the ▲ or ▼ buttons to adjust the BRIGHTNESS, CONTRAST, HUE, SATURATION, and
SHARPNESS of the video output quality. Press ► to confirm the option selected and then change the
setting with the ▲/ ▼ buttons. Press ◄ to go back.
5.SPEAKER SETUP
5.1 “DOWNMIX”
LT/RT: This option allows you to listen to the soundtrack as it would sound in a movie theatre, if the
original movie was recorded in the Pro Logic Dolby Digital format.
STEREO: When 2-channel sound is being played, select this option to obtain stereo sound.
VSS: When 5.1-channel sound is being played, the surround sound effect will be heard on the main
soundtrack.
6.DIGITAL SETUP
6.1 “OP MODE” (dynamic compression)
LINE OUT: This option allows the user to adjust the dynamic compression in order to limit variations in
volume to a level that is suitable for use at night.
RF REMOD: This option switches off dynamic compression for daytime use (the volume variations are
set to normal).
6.2 “DYNAMIC RANGE”
Select “LINE OUT” in OP MODE to adjust the compression rate. Select “FULL” to limit the volume
variations as much as possible. Select “OFF” to switch off the dynamic compression function.
6.3 “DUAL MONO”
Select this sub-menu to setup the L and R output modes. You can choose between 4 modes STEREO,
MONO L, MONO R, and MIX MONO.
PLAYING DVD / CD / VCD DISCS
1. (Open / Close)
Note: Load the disc on the disc slot with disc label facing the front.
• The unit will start playback automatically. Press the
button to eject the disc.
2.
(PLAY/PAUSE)
• Press the
button on the remote control to start playback. Press it again to pause playback.
3. STEP (Frame-by-Frame Advance)
GB-8