User guide

GETTING STARTED & BASIC SETUP
GETTING STARTED
Power supply for the unit
1. Carry out the connections for the unit as shown in “CONNECTIONS”.
2. Insert 2 AAA batteries (supplied) into the battery compartment in the remote control, taking care to
follow the correct polarities.
3. Connect the AC adapter power cord to an AC mains outlet and the other end to the unit’s DC 5V
jack. Press the
button on the unit or on the remote control to turn on the unit.
4. Turn on the TV and set to the correct video-in source.
5. To go to standby mode, press the
button on the remote control or on the unit. If the unit is not to
be used for a long time, please disconnect the power cord from the mains outlet.
Notes:
• The remote control has a range of about 5 meters.
• Replace the remote control batteries when the range starts to reduce.
• If the remote control is not to be used for a long time, remove the batteries to avoid damage caused
by battery leakage.
Precautions when using batteries
1. Use only the size and type of batteries specified.
2. Ensure that you follow the correct polarities marked in the battery compartment when installing the
batteries. Reversed polarities may damage the remote control.
3. Exhausted batteries must be removed because they might leak.
4. Dispose of batteries properly according to the environmental regulations in force.
Inserting a disc
1. Insert a disc with label side facing the front (insertion is automatic). Press the button on the front
panel or the remote control to eject the disc. The unit will read the disc and start to play it, or it will
display a start menu.
Inserting a USB device or an SD/MMC/MS card
• Open the side cover and insert a USB device or SD/MMC/MS card into the unit. Press the
USB/CARD button on the remote control to select the source: DISC, CARD or USB.
Notes:
• Please ensure the USB device or SD/MMC/MS card is correctly inserted..
• This unit cannot support NTFS format. If the unit does not recognize your USB device, please check
the device’s file system and format it in FAT or FAT32.
Although you can watch a movie immediately, to get the best from this unit, it is recommended that
you proceed with the Basic Setup first.
BASIC SETUP
Press the button to turn on the unit and press the SETUP button when no disc has been inserted
or in stop mode to enter the SYSTEM SETUP menu.
Basic Operation
Use the ◄ or ► buttons to select one of the following
menus (icons at the top of the display):
• SYSTEM SETUP
• LANGUAGE SETUP
• AUDIO SETUP
• VIDEO SETUP
• SPEAKER SETUP
• DIGITAL SETUP
2. Use the ▲ or ▼ button to select a menu item. Press ► or ENTER to confirm.
GB-5
1.