Instruction manual

GB-3
TO SET THE ALARM
1. Press and hold the Alarm set button while repeating step 2 and 3 described under " TO SET THE TIME"
to set the desired wake-up time.
2. To check the correct alarm time, press the Alarm set button.
USING THE RADIO / BUZZER ALARM
1. Set the alarm as shown in "TO SET THE ALARM".
2. Follow the procedure in "LISTEN TO THE RADIO" to tune the desired station.
3. Set the Volume Control to your required listening level.
4. Slide the Function Switch to " " position. The radio will turn on to wake you up at the preset time.
5. To wake to the buzzer instead of the radio , set the alarm as shown in "TO SET THE ALARM" .Slide the
Function Switch to " " position. The buzzer will turn on to wake you up at the preset time.
6 To turn off the radio or buzzer, slide the Function Switch to "OFF" position or press the Alarm set button.
SNOOZE FUNCTION
When the radio or buzzer sounds, press the Snooze button to switch off the alarm. Approximately 9 minutes later,
the alarm will switch on again. This snooze cycle will be activated up to 5 times within an hour period. To
stop the snooze cycle, slide the Function switch to "OFF" position or press ALarm set button.
SLEEP FUNCTION
1. Set the Function Switch to "ON", "OFF", " " or " " position.
2. Press the Sleep button. The clock display will show 59 minutes. The radio turns on and off automatically
after 59 minutes.
3. To reduce the automatic shut off time, hold down the Sleep button and press the Minute set button to
adjust to the desired sleep time.
4. To set the automatic play for up to1 hour and 59 minutes, press and hold the Sleep button and press
the Hour set button once. The clock will read 1 hour 59 minutes.
5. To turn the radio off prior to the preset sleep time, simply press the Snooze button.
AUX. IN
Connect an external LINE OUT to AUX. IN socket on the top of the unit.
( AUX IN CABLE NOT INCLUDED )
ANTENNA
The FM radio has a exible wire antenna on the back of the unit, uncoil the wire and extend to its full
length for best reception.
SPECIFICATIONS
Power Source: AC : 230V ~ 50Hz
DC : 9V backup (1x006P)
Frequency range: FM : 87.5 - 108 MHz
Dimension: 133(L) x 69(D) x 133(H) mm
Weight: 510 g
Due to continuing improvement, the features and the design are subject to change without notice.
ADAPTER SPECIFICATION
Input : 230V AC 50Hz 40mA
Output : 9V AC 400 mA