Operation Manual

BMX | BIKE OWNER’S MANUAL 2015 BIKE OWNER’S MANUAL 2015 | BMX

ENGLISH

Replacement of the brake pads/cartridge shoe

Make sure to use the correct brake pad and brake shoe for each side. Those for the

left side are different from those for the right side. Slide the new pad into the shoe

and make sure that the direction is correct and that the security pin holes concord.

Insertion of shoe fixing pin is very critical to keep shoe properly fixed in place

Remove the shoe fixing pin

Remove the shoe by sliding it along the groove of the shoe holder

shoe fixing pin

shoe

for the left

same at front and rear

front

shoe

shoe holder shoe holder

shoe

front

same at front and rear

for the right

shoe

insertion

direction

shoe fixing pin shoe fixing pin

TIRES AND RIMS

Tires should always be inflated within the manufacturer’s recommendations. They are

rated from 40 to 80 lbs. (check your tires).

Higher pressure for smoother roads or heavy riders.

Lower pressure for more shock absorption on rougher terrains.

For example:

INFLATE TO MIN. 3.5 (50PSI) - MAX. 6.0 BAR (85PSI)

RIM AND WEAR OF THE RIM

If the brake system has brake pads, please be aware that the rim will become worn

through the action of braking.

When riding in wet and muddy terrain, for example, the rim is quickly worn out.

The appearance of small cracks or deformation of the brake surface on the rim when

increasing the tire pressure indicates increased wear of the rim. If this occurs, the rim

should be replaced immediately at an authorized dealer.

SCOTT bikes that are fully equipped (lights, mudguard, carrier) have a

wear‑out‑indicator.

Please follow the instructions of the rim manufacturer shown in the manual or on the

rim itself.