Instruction manual

RADIO OPERATION
Listen to the radio
1. Press STANDBY/ ON button to turn on the unit.
2. Press SOURCE button to select radio mode.
3. Press and hold SKIP/ TUNING / button on the
remote control for one second and then release the
button. It will search up / down until a radio station is
received. For fine-tuning, you can press SKIP/
TUNING / button repeatedly step by step.
Note: You can also press TUNING▲/▼ on the unit.
4. Adjust sound volume level by pressing VOLUME + / -
buttons up to maximum level 40.
5. To turn off radio, press STANDBY/ ON once to go to
standby mode.
FM Stereo / Mono selection
1. Press ST/ MO button on the remote control to select
stereo/ mono sound.
2. When FM signal is weak and sound distortion occurs,
it is better to select mono sound.
Note: Extend and position the FM antenna wire such as to achieve optimum
reception.
Preset radio stations
While listening to a station that you want to memorize,
1. Press MENU/ MEMO button on the remote control,
“MEMORY” and “station no.” will blink.
2. Press PRESET▲/▼ button on the remote control to
select a desired station number.
3. Press MENU/ MEMO button again to confirm the
memory setting.
4. You can memorize the stations up to total 30, by
searching to any desired station and then repeating
above steps from (1) to (3).
Listen to a preset station
While listening to a station, press PRESET▲/▼ on the remote control to select the
preset radio station.
GB -6-